This page is applicable to NetConnect X 1.5 and above
Installation of the NetConnect X image is a straight forward operation. This section will pass over the standard OVA/VHD installation process and concentrate on the specific steps required for NetConnect X. For steps on the standard OVA/VHD installation process, please refer to the publicly available VMWare/Hyper-V guides.
Select Your Platform
|Source||Browse to the NetConnect .ova|
|OVF Template Details||For reference only; click Next|
|Name and Location||Name server as required.|
|Disk Format||Select Thick Provision Lazy Zeroed. Ensure you select a network and subnet with access to the desktop/server you wish to access via NetConnect X|
|Network Mapping||Select the relevant pre-configured Network adapter.|
|Ready to Complete||Review and finish.|
|Specify Name and Location||Name your server as required.|
|Specify Generation||Ensure Generation 1 is selected|
|Assign Memory||Allocated required memory. We recommend a minimum of 4096MB|
|Configure Network||5. Select the required Network card. Please note this is required to ensure that access to the Network configuration can be achieved.|
|Connect Virtual Hard Disk||Select 'Use an existing virtual hard disk' and browse and select the NetConnect VHD that was downloaded from the Partner Portal.|
|Summary||Review and finish.|
Now your NetConnect server is installed, you’ll need to configure the basic network settings. For details on how to complete this, please proceed to our Network Configuration page.